Putting Wood On Stairs

My husband and i recently tore the carpet from our stairs and painted the wood underneath creating a fresh, clean, and modern look! we did this project over a full weekend and two additional weeks nights following. This is our stairs before. The carpet was old and d*rty giving the entry a very dark and dated feel. Our main goal was to rip off the carpet, see what wood was underneath, and. Listed here are wallpapers about how to change stairs from carpet to wood diy hometalk, gray hardwood stairs, hardwood stairs with runner, hardwood stairs with white risers, modern wood stairs, laminate stairs, etc.

A simple way to make your old carpet vinyl or plywood stairs look beautiful and on a budget with this diy tutorial we show you how to install wood treads we also share the cost to install stair treads and risers it x27 s cheaper than you think attaching stair treads can be a simple project we show you how here stairs stairsmakeover treads

Historically the hardwood flooring contractor x27 s job ended on level ground and an experienced trim carpenter would be called in to construct stairs but now more and more flooring contractors are taking on this task themselves and are being paid accordingly the following process illustrates one method of installing boxed in stairs

The risers go on next the international building code specifies a maximum riser height of 7 inches so a single laminate plank usually suffices but you may prefer to use pine poplar or some other stainable wood instead the riser must come flush with the surface of the tread and the stair nose which goes on last curls around the top of the riser and either fits flush against the laminate

By contrast wooden stairs can be cleaned with a whisk broom and dustpan with carpeted stairs you will never be able to adequately clean that angle where tread and riser meet installation speed installing carpet on stairs might be an all morning affair for professional carpet installers they can do it in about two minutes per stair

Clean the wood with a damp cloth and detergent to make sure all dust dirt and grease are removed from the wood let dry before putting down a coat of stain or paint always go over the surface again with swiffer duster or tack cloth to remove any dust hair bugs or specs of dirt off the surface

Disclaimer: images, articles or videos on this website sometimes come from various other media sources. Copyright is fully held by the source. If there are problems related to this, you can contact us on this page.